Aug/2019 New 200-125 Dumps in VCE and PDF

Kellyeperry

Member
Member
Joined
Jun 12, 2016
Messages
375
Reaction score
30
Points
18
Some new 200-125 Exam Questions:

New Questions
Which two spanning-tree port states does RSTP combine to allow faster convergence? (Choose two.)

A. blocking
B. listening
C. learning
D. forwarding
E. discarding

Answer: AB

New Questions
Which technology can enable multiple VLANs to communicate with one another?

A. inter-VLAN routing using a Layer 3 switch
B. inter-VLAN routing using a Layer 2 switch
C. intra-VLAN routing using router on a stick
D. intra-VLAN routing using a Layer 3 switch

Answer: A

New Questions
In which three ways is an IPv6 header simpler than an IPv4 header? (Choose three.)

A. Unlike IPv4 headers, IPv6 headers have a fixed length.
B. IPv6 uses an extension header instead of the IPv4 Fragmentation field.
C. IPv6 headers eliminate the IPv4 Checksum field.
D. IPv6 headers use the Fragment Offset field in place of the IPv4 Fragmentation field.
E. IPv6 headers use a smaller Option field size than IPv4 headers.
F. IPv6 headers use a 4-bit TTL field, and IPv4 headers use an 8-bit TTL field.

Answer: ABC

More at:
1.2019 New 200-125 Exam Dumps (PDF and VCE)Share:

2.2019 New 200-125 Exam Questions & Answers PDF:
 

Kellyeperry

Member
Member
Joined
Jun 12, 2016
Messages
375
Reaction score
30
Points
18
New Question
Which command can you enter to view the ports that are assigned to VLAN 20?

A. Switch#show vlan id 20
B. Switch#show ip interface brief
C. Switch#show interface vlan 20
D. Switch#show ip interface vlan 20

Answer: A

New Question
If primary and secondary root switches with priority 16384 both experience catastrophic losses, which tertiary switch can take over?

A. a switch with priority 20480
B. a switch with priority 8192
C. a switch with priority 4096
D. a switch with priority 12288

Answer: A

New Question
Which two statements about IPv6 and routing protocols are true? (Choose two.)

A. Link-local addresses are used to form routing adjacencies.
B. OSPFv3 was developed to support IPv6 routing.
C. EIGRP, OSPF, and BGP are the only routing protocols that support IPv6.
D. Loopback addresses are used to form routing adjacencies.
E. EIGRPv3 was developed to support IPv6 routing.

Answer: AB

New Question
Which two features can dynamically assign IPv6 addresses? (Choose two.)

A. IPv6 stateless autoconfiguration
B. DHCP
C. NHRP
D. IPv6 stateful autoconfiguration
E. ISATAP tunneling

Answer: AB

New Questions
What is the danger of the permit any entry in a NAT access list?

A. It can lead to overloaded resources on the router.
B. It can cause too many addresses to be assigned to the same interface.
C. It can disable the overload command.
D. It prevents the correct translation of IP addresses on the inside network.

Answer: A

New Questions
Which protocol is the Cisco proprietary implementation of FHRP?

A. HSRP
B. VRRP
C. GLBP
D. CARP

Answer: A

New Questions
Which two statements about late collisions are true? (Choose two.)

A. They may indicate a duplex mismatch.
B. By definition, they occur after the 512th bit of the frame has been transmitted.
C. They indicate received frames that did not pass the FCS match.
D. They are frames that exceed 1518 bytes.
E. They occur when CRC errors and interference occur on the cable.

Answer: AB

New Questions
Which command can you enter to display the operational status of the network ports on a router?

A. show interface switchport
B. show ip interface brief
C. show running-config interface fastethernet 0/1
D. show interface status

Answer: B
 

Kellyeperry

Member
Member
Joined
Jun 12, 2016
Messages
375
Reaction score
30
Points
18
Sep/2019 New 200-125 Exam Questions,

QUESTION 429
Which command can you enter to display the operational status of the network ports on a router?

A. show interface switchport
B. show ip interface brief
C. show running-config interface fastethernet 0/1
D. show interface status

Answer: B

QUESTION 430
Refer to the exhibit. What is the effect of the given configuration?


A. It configures an inactive switch virtual interface.
B. It configures an active management interface.
C. It configures the native VLAN.
D. It configures the default VLAN.

Answer: A

QUESTION 431
Which command can you enter to view the ports that are assigned to VLAN 20?

A. Switch#show vlan id 20
B. Switch#show ip interface brief
C. Switch#show interface vlan 20
D. Switch#show ip interface vlan 20

Answer: A

QUESTION 432
If primary and secondary root switches with priority 16384 both experience catastrophic losses, which tertiary switch can take over?

A. a switch with priority 20480
B. a switch with priority 8192
C. a switch with priority 4096
D. a switch with priority 12288

Answer: A


Download 2019 New 200-125 Exam Dumps (PDF and VCE) at:

Get 2019 Free Braindump2go 200-125 Exam Questions from Google Drive:
 

MartyBueno

Member
Member
Joined
Jun 15, 2019
Messages
339
Reaction score
1
Points
18
100% Success Opt Now: https://www.theexamcerts.com/Cisco/200-125-pdf-exam-dumps If you want to prepare for 200-125 Cisco Certified Network Associate exam in shortest possible time, with minimum effort but for the most effective result, you can use TheExamCerts Cisco 200-125 exam dumps. TheExamCerts has a variety of 200-125 Cisco Certified Network Associate Routing & Switching certification exam braindumps and other exam preparation material which gives you consolidation in the ways of your interest and ease. TheExamCerts delivers Cisco 200-125 exam dumps which give you detailed and logical coverage of Cisco 200-125 exam pattern syllabus and provide you with the real 200-125 exam environment as these products are built by IT examiners so you experience the real Cisco 200-125 exam features in our 200-125 exam products. Try free demo of Cisco 200-125 exam questions before buy actual dumps questions. Follow this link and get 20% discount offer [Limited Time]:
 
Top